Leak repair, tap fitting and bathroom plumbing support.
Plumbing Service in Singapore
Fast plumbing support for kitchens, bathrooms and utility areas, including leaks, taps, basins, pipes and drainage checks.
About Our Plumbing Service
Water problems get worse the longer they're left, whether that's a slow drip behind a cabinet or a cistern that's quietly running all day. We prioritise tracing the actual source of a leak before touching any fitting, because a tap that's been over-tightened to stop a drip often just moves the leak further down the line. Our plumbers carry common tap, hose and trap parts for same-visit fixes, and every repair is pressure-tested before we consider the job done.
What We Cover
- Leak detection and repair
- Tap and mixer replacement
- Basin and sink fitting
- Pipe and hose work
- Toilet cistern repair
- Drainage and floor trap check
- Water heater connection
- Bidet and shower fitting
- Kitchen sink installation
- Commercial washroom plumbing
Best For
- Kitchen sinks
- Bathroom fixtures
- Service yards
- Commercial wash areas
- Rental unit plumbing checks
- Renovation plumbing work
Common Problems
- Dripping or leaking taps
- Low water pressure
- Leaking pipe joints
- Running or noisy toilet cistern
- Blocked floor trap smell
- Slow-draining sink or basin
- Loose or wobbly basin fittings
Signs You Need This Service
- Water is pooling near a cabinet or under a sink
- The water bill has risen without a clear reason
- A toilet cistern keeps refilling on its own
- There's a persistent smell from a floor trap
What's Included in Plumbing
Leak repair
Tracing and sealing leaks at taps, pipe joints and under-sink connections.
Tap and fixture replacement
Swapping out worn taps, mixers and basin fittings.
Toilet and cistern repair
Fixing running cisterns, weak flushes and loose toilet bowls.
Drainage and floor traps
Clearing slow drains and addressing floor trap odours.
New installation
Fitting new sinks, basins, water heaters and bidets.
Plumbing Work in Singapore
How the Job Runs
Trace the water source and shut off the nearest supply
Confirm the cause and required replacement parts
Seal, fit and tighten connections with correct sealant or tape
Pressure-test the repaired section
Clean the work area and check for any residual drips
Plumbing Pricing
Final pricing depends on scope and site conditions. These ranges are a starting guide.
Single tap or fixture
From SGD 100
One tap, mixer or basin fitting replacement.
Leak repair
From SGD 120
Includes leak tracing, part replacement and pressure test.
Multi-fixture or installation job
Quote after site visit
New sinks, water heaters or multiple fixtures.
Materials and Visit Notes
If there is active leaking, turn off the nearest valve and send a short video before our plumber arrives.
Why Choose Us
- We trace the source of a leak before replacing any part
- Every repaired joint is pressure-tested before we leave
- Common parts are carried on-hand for same-visit fixes
- We advise honestly when a fixture is better replaced than repaired
Need plumbing help today?
Send photos, your location and preferred timing. We will confirm the scope, estimated labour and material needs before the visit.
WhatsApp +65 8162 4967Service Questions
Can you replace taps and mixers?
Yes. We replace taps, mixers, hoses, traps and common bathroom or kitchen fittings.
What should I do during a leak?
Turn off the nearest valve if safe, keep the area dry and send us photos or a short video for faster advice.
Why does my tap keep dripping after I tightened it?
Over-tightening often damages the washer or cartridge inside. The fix is usually replacing that part, not tightening further.
Do you handle blocked drains?
Yes, for common floor trap and basin drainage issues. Severe blockages may need a follow-up assessment on-site.